Geeetech

Does anyone know the ACTUAL fuse that should be used at the power supply cable? Seems to be a lot of disagreement over it. If mine is too low rated, that could be the issue, although I'm using an exact match for the one that came with it.

Is there an alternative power supply to put in rather than the original? It appears I need to replace mine, but m reluctant to use the same one again. Also, without any mods?

I've rolled back to firmware 1.35.56 and this issue has stopped. Doesn't make sense why upgrading firmware would basically render the unit unusable, but I guess they "know what they're doing."

Mine doesn't seem to be popping during any specific event. It dies during printing. Could be an hour in, or days in, as just happened today. I started a print 2 days ago, and all was going well until I noticed it had stopped. Another fuse blown. Octoprint showed as steady temp on both the hotend, an...

Currently battling this issue myself. My A30 was great for a few months. Now I can't even use it. I've been throwing cash at it trying to keep it going. I'm about done. And I'll never buy Geeetech again.

So my A30 started out great. Good prints, no issues. all was good. Then one day, a problem. Fixed it. Then another. Fixed it, then another. And on down the the line. I'm ready to chuck it. At any rate, the issue I'm having now, after getting a new hotend installed, is the print just stopping. Everyt...

Yes. No different.

Do does anyone else have this working with octoprint? I've found two slightly different snippets of gcode to put into the octoprint gcode settings, but they both do the same thing. It pauses, lifts, and moves to home so I can change filament, but when I hit resume, it goes back to place, and spits o...

GreenEyedExplorer wrote: ↑

Thu Jun 13, 2019 12:29 am

Maybe this is solution for you:
https://www.youtube.com/watch?v=OLGSz6XT76s

Yeah it pretty much was. I ended up printing the new end stops and adjusting. It worked like a charm. Didn't take long to zero them in.

... even my A30 did not print in the middle (offset to the front and right), so I could not use the entire print bed. Solution: print a symmetrical test object, centered with e.g. Cura, measure distances to the edges, and enter half the page difference for the slicer (such as Cura) under Settings -...