Search found 6 matches
- Sat Dec 21, 2019 12:55 am
- Forum: Geeetech A20M
- Topic: my own disign fan duct.
- Replies: 4
- Views: 8829
Re: my own disign fan duct.
Hi. Your files are not available anymore. Can you put them on thingiverse?
- Mon Jun 25, 2018 9:48 pm
- Forum: Geeetech A30 Series
- Topic: Geeetech A30 and Cura
- Replies: 7
- Views: 19178
Re: Geeetech A30 and Cura
Thanks. I already did and works.
- Mon Jun 25, 2018 9:46 pm
- Forum: Firmware
- Topic: How to burn the firmware for E180
- Replies: 11
- Views: 69736
Re: How to burn the firmware for E180
Hi, can anyone tell me how to connect ST-link to this board? I can't do anything with STMFlashLoader Demo, no response from printer.
- Mon Jun 04, 2018 11:55 pm
- Forum: Geeetech A30 Series
- Topic: Geeetech A30 and Cura
- Replies: 7
- Views: 19178
Re: Geeetech A30 and Cura
This video is only how to setup profile in Cura. That is not the problem. My problem is that Cura doesn't recognize my printer on any of my two computers.
- Fri Jun 01, 2018 3:32 pm
- Forum: Firmware
- Topic: New Firmware toolkits for E180/A30/D200
- Replies: 15
- Views: 1525082
Re: Toolkits for E180/A30/D200
I keep receiving "Fail to execute script main". Solution anyone?
- Fri Jun 01, 2018 3:25 pm
- Forum: Geeetech A30 Series
- Topic: Geeetech A30 and Cura
- Replies: 7
- Views: 19178
Geeetech A30 and Cura
Hi
my printer connect easily to Simplify3D and EasyPrint but Cura doesn't recognize it. Any suggestions?
my printer connect easily to Simplify3D and EasyPrint but Cura doesn't recognize it. Any suggestions?