Geeetech

Good job!
Yes 'am planning to use GitHub, but today i didn't have enough time to do it...

So what exactly was the bug you supposedly fixed when it comes to component cooling fan?

I'am using the wrong PIN-Number! The fan didn't work using the wrong pin. Thats i'ved fixed.

It's a stupid question but the power supply are connected with the yellow "Du Pont"-Adaptor to the mainboard?
If yes, pulled out the connector and measure the voltage.

You do it onto your own risk, please!!!

Wich firmware you are using? The firmware with boot loader included? Please don't use this one!!! Use the firmware without the boot loader. With Arduino you need to use the correct version of the arduino -ide to flash the printer. Onto GitHub you can found the newest version of the firmware: https:/...

Maybe it helps...

https://www.youtube.com/watch?v=MlQdz1E ... gs=pl%2Cwn

These user talking about the fans, but at the video you could seen the "Autolevel-BL-Touch Sensor" onto the A10 self made.
Thats a way you can use byself??

To test the part cooling fan, you could use the following code: M106 S255
M106 - set fan speed. S255 full speed, S127 50% speed, S0 stop fan.

please wrote to [email protected] to ask them please.
The hotend looks like it could fit.

You need the hotend completely?

Or only the nozzle? Its a 0.4mm nozzle you can buy it at amaz... or other searching at geeetechs website

https://www.geeetech.com/brass-m6-nozzl ... p-904.html

Hi Michael, thanks for your work. Got my Printer Yesterday and it is one of These faulty head bed guide. I know you just turn that compenent and solve this Problem. But did you have a good contact for spare part of this Printer? It is not on mine to rebuild this think to make it work, and in the ca...

you can’t just download something, compile them and believe it works. The original firmware from here: http://www.geeetech.com/forum/download/file.php?id=4279 made with an very old version from Marlin and develop with an very old version from the Arduino-IDE. Maybe I think it’s version 1.0.1 or olde...

Wich temperature are you using? 200°Celsius? You can set the temperature higher. Set the nozzle temperature to 230°Celsius and show the nozzle comming filament outside. Possible that the nozzle is closed or congested. If never comes out, set the temperature of the nozzle higher as 230°Celsius to mel...